K0FTT Automobiles

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1770103089	96 Count	42 Count
1770102489	87 Count	39 Count
1770101889	84 Count	37 Count
1770101289	75 Count	33 Count
1770100689	67 Count	31 Count
1770100089	62 Count	28 Count
1770099489	53 Count	24 Count
1770098888	45 Count	21 Count
1770098288	42 Count	19 Count
1770097688	32 Count	14 Count
1770097088	25 Count	12 Count
1770096488	20 Count	9 Count
1770095888	11 Count	5 Count
1770095288	2 Count	2 Count
1770094688	1001 Count	432 Count
1770094088	991 Count	427 Count
1770093488	985 Count	425 Count
1770092888	980 Count	422 Count
1770092288	972 Count	418 Count
1770091688	964 Count	415 Count
1770091087	961 Count	413 Count
1770090487	951 Count	408 Count
1770089887	945 Count	406 Count
1770089287	941 Count	403 Count
1770088687	933 Count	399 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)