K0FTT Automobiles

My position About ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768176089	36 Count	375 Count	32 Count
1768174288	27 Count	275 Count	24 Count
1768172488	19 Count	187 Count	17 Count
1768170687	8 Count	87 Count	7 Count
1768168887	0 Count	0 Count	0 Count
1768167092	59 Count	921 Count	53 Count
1768165292	49 Count	803 Count	44 Count
1768163491	43 Count	711 Count	39 Count
1768161691	29 Count	573 Count	26 Count
1768159890	22 Count	406 Count	20 Count
1768158089	14 Count	286 Count	13 Count
1768156289	7 Count	166 Count	7 Count
1768154488	81 Count	1048 Count	73 Count
1768152688	71 Count	888 Count	64 Count
1768150887	63 Count	763 Count	57 Count
1768149086	50 Count	638 Count	45 Count
1768147286	43 Count	543 Count	39 Count
1768145492	35 Count	445 Count	32 Count
1768143692	27 Count	343 Count	25 Count
1768141891	18 Count	231 Count	17 Count
1768140091	8 Count	100 Count	8 Count
1768138290	91 Count	1091 Count	82 Count
1768136489	85 Count	985 Count	77 Count
1768134689	76 Count	876 Count	69 Count
1768132888	67 Count	762 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)