K0FTT Automobiles

My position About ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765995433	249 Count	689 Count	220 Count
1765993633	231 Count	641 Count	203 Count
1765991831	227 Count	622 Count	200 Count
1765990031	206 Count	562 Count	180 Count
1765988230	202 Count	551 Count	177 Count
1765986430	196 Count	539 Count	172 Count
1765984636	189 Count	517 Count	166 Count
1765982835	181 Count	501 Count	159 Count
1765981035	177 Count	488 Count	156 Count
1765979234	173 Count	472 Count	153 Count
1765977433	169 Count	456 Count	150 Count
1765975633	160 Count	435 Count	142 Count
1765973832	150 Count	399 Count	133 Count
1765972031	136 Count	361 Count	120 Count
1765970231	130 Count	344 Count	115 Count
1765968430	119 Count	308 Count	105 Count
1765966629	115 Count	294 Count	102 Count
1765964829	109 Count	281 Count	97 Count
1765963036	105 Count	267 Count	94 Count
1765961235	97 Count	250 Count	87 Count
1765959435	93 Count	236 Count	84 Count
1765957634	89 Count	220 Count	81 Count
1765955833	54 Count	164 Count	47 Count
1765954033	50 Count	151 Count	44 Count
1765952232	39 Count	113 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)