K0FTT Automobiles

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766072562	489 Count	508 Count	204 Count
1766071665	469 Count	488 Count	188 Count
1766070750	459 Count	470 Count	181 Count
1766069845	440 Count	445 Count	165 Count
1766068939	435 Count	440 Count	163 Count
1766068033	429 Count	434 Count	161 Count
1766067128	425 Count	428 Count	159 Count
1766066222	419 Count	419 Count	156 Count
1766065316	415 Count	411 Count	155 Count
1766064411	410 Count	405 Count	153 Count
1766063505	401 Count	400 Count	151 Count
1766062599	388 Count	393 Count	149 Count
1766061693	384 Count	387 Count	147 Count
1766061379	382 Count	387 Count	147 Count
1766060473	377 Count	384 Count	145 Count
1766059566	374 Count	379 Count	143 Count
1766058661	322 Count	375 Count	141 Count
1766057753	208 Count	374 Count	141 Count
1766056847	205 Count	367 Count	139 Count
1766055941	202 Count	361 Count	137 Count
1766055036	199 Count	354 Count	135 Count
1766054130	197 Count	350 Count	134 Count
1766053224	195 Count	345 Count	133 Count
1766052319	192 Count	339 Count	131 Count
1766051413	189 Count	331 Count	129 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)