K0FTT Automobiles

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1770097761	298 Count	534 Count	162 Count
1770096861	298 Count	532 Count	161 Count
1770095961	298 Count	528 Count	159 Count
1770095060	298 Count	524 Count	157 Count
1770094160	298 Count	520 Count	155 Count
1770093260	298 Count	516 Count	153 Count
1770092360	298 Count	513 Count	152 Count
1770091460	298 Count	510 Count	150 Count
1770090560	298 Count	507 Count	149 Count
1770089660	298 Count	503 Count	148 Count
1770088760	298 Count	501 Count	147 Count
1770087860	298 Count	500 Count	146 Count
1770086960	298 Count	498 Count	145 Count
1770086060	298 Count	496 Count	144 Count
1770085160	298 Count	493 Count	142 Count
1770084260	298 Count	489 Count	141 Count
1770083360	298 Count	487 Count	140 Count
1770082460	298 Count	485 Count	139 Count
1770082351	298 Count	485 Count	139 Count
1770080895	298 Count	483 Count	138 Count
1770080521	298 Count	483 Count	138 Count
1770079621	298 Count	480 Count	137 Count
1770078721	298 Count	478 Count	136 Count
1770077821	298 Count	476 Count	136 Count
1770076921	298 Count	473 Count	135 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)