K0FTT Automobiles

My position About ☰

reset

CR7BQX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768233690	44 Count	710 Count
1768231888	43 Count	702 Count
1768230087	42 Count	694 Count
1768228285	41 Count	674 Count
1768226484	40 Count	650 Count
1768224683	39 Count	628 Count
1768222881	38 Count	605 Count
1768221080	37 Count	591 Count
1768219295	36 Count	575 Count
1768217494	35 Count	553 Count
1768215692	34 Count	543 Count
1768213891	33 Count	537 Count
1768212089	32 Count	531 Count
1768210288	31 Count	525 Count
1768208487	30 Count	515 Count
1768206685	29 Count	503 Count
1768204884	28 Count	487 Count
1768203082	27 Count	475 Count
1768201281	26 Count	467 Count
1768199479	25 Count	449 Count
1768197695	24 Count	433 Count
1768195894	23 Count	413 Count
1768194092	22 Count	394 Count
1768192291	21 Count	377 Count
1768190489	20 Count	367 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)