K0FTT Automobiles

My position About ☰

reset

SO3Z-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO3Z-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768211558	299 Count	887 Count	256 Count
1768209757	288 Count	852 Count	246 Count
1768207956	278 Count	820 Count	237 Count
1768206156	268 Count	791 Count	228 Count
1768204355	257 Count	760 Count	218 Count
1768202554	246 Count	728 Count	208 Count
1768200754	234 Count	694 Count	197 Count
1768198953	223 Count	662 Count	187 Count
1768197163	211 Count	623 Count	176 Count
1768168063	206 Count	623 Count	176 Count
1768166262	198 Count	596 Count	169 Count
1768164461	190 Count	570 Count	162 Count
1768162661	182 Count	544 Count	155 Count
1768160860	174 Count	519 Count	148 Count
1768159060	167 Count	494 Count	142 Count
1768157259	159 Count	468 Count	135 Count
1768155458	151 Count	441 Count	128 Count
1768153658	144 Count	414 Count	122 Count
1768151865	135 Count	389 Count	115 Count
1768151828	131 Count	389 Count	115 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)