K0FTT Automobiles

My position About ☰

reset

EC5CIA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1760096758	228 Count	787 Count
1760095854	227 Count	787 Count
1760094949	226 Count	784 Count
1760094045	225 Count	783 Count
1760093141	224 Count	783 Count
1760092236	223 Count	782 Count
1760091332	222 Count	781 Count
1760090428	221 Count	779 Count
1760089523	220 Count	779 Count
1760088619	219 Count	779 Count
1760088140	218 Count	778 Count
1760087235	217 Count	777 Count
1760086331	216 Count	777 Count
1760085427	215 Count	777 Count
1760084522	214 Count	776 Count
1760083618	213 Count	775 Count
1760082713	212 Count	775 Count
1760081809	211 Count	775 Count
1760080905	210 Count	774 Count
1760080000	209 Count	774 Count
1760079096	208 Count	774 Count
1760078192	207 Count	774 Count
1760077287	206 Count	772 Count
1760076383	205 Count	772 Count
1760075478	204 Count	772 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)