K0FTT Automobiles

My position About ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768212154	393 Count	570 Count	97 Count
1768210354	387 Count	556 Count	95 Count
1768208552	382 Count	547 Count	94 Count
1768206751	376 Count	533 Count	92 Count
1768204951	371 Count	524 Count	91 Count
1768203150	365 Count	510 Count	89 Count
1768201349	353 Count	496 Count	87 Count
1768199548	337 Count	482 Count	85 Count
1768197747	331 Count	468 Count	83 Count
1768195947	325 Count	448 Count	81 Count
1768194146	319 Count	437 Count	79 Count
1768192345	313 Count	427 Count	77 Count
1768190552	306 Count	419 Count	74 Count
1768188751	300 Count	407 Count	72 Count
1768186950	294 Count	397 Count	70 Count
1768185150	288 Count	389 Count	68 Count
1768183349	282 Count	379 Count	66 Count
1768181548	276 Count	371 Count	64 Count
1768179746	270 Count	360 Count	62 Count
1768177946	264 Count	349 Count	60 Count
1768176145	258 Count	337 Count	58 Count
1768174344	253 Count	325 Count	57 Count
1768172543	247 Count	314 Count	55 Count
1768170743	241 Count	304 Count	53 Count
1768168968	234 Count	295 Count	50 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)