K0FTT Automobiles

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765988601	88 Count	305 Count	79 Count
1765986800	57 Count	262 Count	49 Count
1765983745	17 Count	160 Count	15 Count
1765981944	11 Count	105 Count	10 Count
1765980144	5 Count	49 Count	5 Count
1765978343	153 Count	1014 Count	135 Count
1765976542	147 Count	967 Count	130 Count
1765974741	140 Count	919 Count	125 Count
1765969830	115 Count	745 Count	104 Count
1765968029	106 Count	684 Count	96 Count
1765966237	96 Count	626 Count	87 Count
1765964436	90 Count	564 Count	82 Count
1765962635	81 Count	519 Count	74 Count
1765960834	70 Count	461 Count	64 Count
1765959034	62 Count	410 Count	57 Count
1765957233	44 Count	274 Count	40 Count
1765955433	32 Count	206 Count	29 Count
1765953631	25 Count	163 Count	23 Count
1765951831	17 Count	91 Count	16 Count
1765950030	6 Count	31 Count	6 Count
1765948229	225 Count	1017 Count	174 Count
1765946428	218 Count	978 Count	168 Count
1765944636	212 Count	944 Count	163 Count
1765942835	207 Count	907 Count	159 Count
1765941034	200 Count	872 Count	153 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)