K0FTT Automobiles

My position About ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765983413	429 Count	392 Count	304 Count
1765981620	423 Count	391 Count	303 Count
1765979821	420 Count	389 Count	301 Count
1765978018	417 Count	387 Count	299 Count
1765976216	414 Count	385 Count	297 Count
1765974416	412 Count	384 Count	296 Count
1765972615	410 Count	382 Count	295 Count
1765970814	408 Count	381 Count	294 Count
1765969013	405 Count	379 Count	292 Count
1765967213	402 Count	377 Count	290 Count
1765965412	397 Count	373 Count	286 Count
1765963611	395 Count	372 Count	285 Count
1765961812	392 Count	370 Count	283 Count
1765960017	387 Count	370 Count	283 Count
1765958216	385 Count	369 Count	282 Count
1765956416	376 Count	361 Count	274 Count
1765954615	375 Count	361 Count	274 Count
1765952814	372 Count	359 Count	272 Count
1765951013	362 Count	350 Count	263 Count
1765949213	357 Count	345 Count	259 Count
1765947412	352 Count	340 Count	255 Count
1765945611	347 Count	335 Count	251 Count
1765943810	339 Count	326 Count	244 Count
1765942010	334 Count	319 Count	240 Count
1765940210	329 Count	312 Count	236 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)