K0FTT Automobiles

My position About ☰

reset

SN2DP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN2DP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765988524	810 Count	756 Count	577 Count
1765987623	806 Count	753 Count	574 Count
1765986723	805 Count	752 Count	574 Count
1765985822	800 Count	748 Count	570 Count
1765984921	798 Count	747 Count	569 Count
1765984021	797 Count	747 Count	569 Count
1765983120	792 Count	743 Count	565 Count
1765982219	788 Count	740 Count	562 Count
1765981319	785 Count	738 Count	560 Count
1765980418	777 Count	731 Count	553 Count
1765979517	774 Count	728 Count	551 Count
1765978617	769 Count	724 Count	547 Count
1765977716	767 Count	722 Count	546 Count
1765976816	763 Count	719 Count	543 Count
1765975915	759 Count	715 Count	540 Count
1765975014	754 Count	711 Count	536 Count
1765974114	750 Count	707 Count	533 Count
1765973213	747 Count	705 Count	531 Count
1765972327	743 Count	701 Count	528 Count
1765971426	741 Count	699 Count	527 Count
1765970526	737 Count	696 Count	524 Count
1765969625	735 Count	694 Count	523 Count
1765968724	731 Count	690 Count	520 Count
1765967824	729 Count	689 Count	519 Count
1765966923	725 Count	685 Count	516 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)