K0FTT Automobiles

My position About ☰

reset

WV5Y-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WV5Y-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1768508758	3728	957	82	1209	8092
1768508636	4997	995	84	1204	8092
1768508513	5105	999	83	1209	8092
1768508397	5112	1028	85	1210	8093
1768508275	5112	1015	84	1210	8094
1768508158	5104	1014	86	1210	8094
1768508037	5120	1020	85	1219	8094
1768507917	5104	1009	85	1216	8094
1768507800	5104	1027	86	1222	8096
1768507678	5104	1018	85	1218	8096
1768507555	5111	1020	67	1220	8096
1768507428	5128	1048	110	1261	8096
1768507317	5126	1086	59	1208	8097
1768507203	5122	1075	63	1204	8098
1768507077	5126	1071	60	1213	8098
1768506954	5127	1060	56	1218	8099
1768506828	5120	1061	110	1258	8098
1768506719	5123	1083	58	1207	8100
1768506592	5121	1056	58	1188	8100
1768506475	5123	1078	52	1187	8101
1768506352	3874	1016	87	1202	8100
1768506329	3022	927	176	1210	8106
1768504835	3022	927	90	1210	8106
1768504720	4686	977	100	1238	8106
1768504592	5104	1039	93	1288	8105

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)