K0FTT Automobiles

My position About ☰

reset

F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768161482	318 Count	574 Count	222 Count
1768159678	285 Count	493 Count	196 Count
1768157875	250 Count	414 Count	168 Count
1768156071	215 Count	323 Count	141 Count
1768156056	214 Count	323 Count	141 Count
1768154794	208 Count	323 Count	141 Count
1768154752	207 Count	323 Count	141 Count
1768154099	204 Count	323 Count	141 Count
1768154074	203 Count	323 Count	141 Count
1768153614	195 Count	304 Count	135 Count
1768153560	193 Count	304 Count	135 Count
1768153554	192 Count	304 Count	135 Count
1768153317	191 Count	300 Count	135 Count
1768153300	189 Count	299 Count	135 Count
1768153232	187 Count	293 Count	134 Count
1768153021	184 Count	290 Count	132 Count
1768152713	179 Count	287 Count	129 Count
1768148588	122 Count	155 Count	90 Count
1768148480	118 Count	153 Count	88 Count
1768148124	104 Count	139 Count	76 Count
1768144997	103 Count	139 Count	76 Count
1768143193	74 Count	95 Count	54 Count
1768141390	49 Count	65 Count	37 Count
1768139586	19 Count	27 Count	13 Count
1768137782	730 Count	1009 Count	505 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)