K0FTT Automobiles

My position About ☰

reset

W5QZ-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W5QZ-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1764298907	4040	0	40	1319	8164
1764298793	4040	0	37	1325	8163
1764298644	4040	0	89	1335	8163
1764298557	4040	0	94	1337	8164
1764294767	3848	37	76	1308	8163
1764294640	3848	328	73	1318	8164
1764294528	3841	328	80	1327	8164
1764294411	3848	328	91	1336	8164
1764294331	3848	328	89	1341	8163
1764294165	3848	328	78	1322	8163
1764294046	3848	328	76	1323	8163
1764293927	3848	328	82	1328	8163
1764293819	3848	328	83	1333	8164
1764293704	3848	328	85	1335	8163
1764293577	3848	328	87	1329	8163
1764293464	3843	328	84	1332	8162
1764293333	3848	328	81	1327	8162
1764293206	3848	328	77	1325	8161
1764293081	3830	325	79	1332	8161
1764292986	3824	320	104	1351	8161
1764292906	3848	328	93	1349	8162
1764292731	3824	324	81	1334	8161
1764292606	3848	328	91	1348	8161
1764292526	3848	328	130	1367	8161
1764292446	3848	328	98	1356	8160

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)