K0FTT Automobiles

My position About ☰

reset

F6DEV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DEV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1768171758	834 Count	255 Count	118 Count
1768171155	807 Count	242 Count	110 Count
1768170552	785 Count	235 Count	106 Count
1768169947	759 Count	226 Count	100 Count
1768169344	730 Count	214 Count	96 Count
1768168742	711 Count	209 Count	93 Count
1768168136	682 Count	201 Count	90 Count
1768167533	657 Count	192 Count	84 Count
1768166930	637 Count	187 Count	82 Count
1768166327	615 Count	177 Count	78 Count
1768165723	592 Count	167 Count	73 Count
1768165120	575 Count	163 Count	71 Count
1768164517	553 Count	151 Count	67 Count
1768163914	530 Count	140 Count	60 Count
1768163311	519 Count	134 Count	58 Count
1768162708	494 Count	124 Count	54 Count
1768162105	477 Count	117 Count	51 Count
1768161502	453 Count	113 Count	48 Count
1768160899	420 Count	105 Count	45 Count
1768160296	399 Count	100 Count	44 Count
1768159693	372 Count	91 Count	41 Count
1768159087	344 Count	85 Count	37 Count
1768158483	321 Count	76 Count	32 Count
1768157880	293 Count	68 Count	28 Count
1768157277	258 Count	52 Count	19 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)