K0FTT Automobiles

My position About ☰

reset

SP6DJA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6DJA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765984137	145 Count	377 Count	80 Count
1765983537	135 Count	354 Count	71 Count
1765982936	134 Count	348 Count	71 Count
1765982335	132 Count	344 Count	70 Count
1765981735	131 Count	338 Count	70 Count
1765981134	130 Count	331 Count	70 Count
1765979933	127 Count	309 Count	69 Count
1765979333	123 Count	297 Count	66 Count
1765978732	120 Count	291 Count	64 Count
1765978132	118 Count	289 Count	63 Count
1765977531	116 Count	281 Count	62 Count
1765976930	113 Count	275 Count	60 Count
1765976330	111 Count	273 Count	59 Count
1765975729	110 Count	268 Count	59 Count
1765975129	107 Count	261 Count	57 Count
1765974528	105 Count	255 Count	56 Count
1765973928	104 Count	250 Count	56 Count
1765973327	100 Count	242 Count	53 Count
1765972727	98 Count	238 Count	52 Count
1765972126	96 Count	232 Count	51 Count
1765971526	92 Count	222 Count	48 Count
1765970925	90 Count	218 Count	47 Count
1765970325	88 Count	214 Count	46 Count
1765969724	84 Count	206 Count	43 Count
1765969123	82 Count	201 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)