K0FTT Automobiles

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770082613	527 Count	30 Count	21 Count
1770080686	525 Count	30 Count	21 Count
1770078759	523 Count	30 Count	21 Count
1770076832	521 Count	30 Count	21 Count
1770074906	519 Count	30 Count	21 Count
1770072979	517 Count	30 Count	21 Count
1770070646	514 Count	30 Count	21 Count
1770068719	512 Count	30 Count	21 Count
1770066793	510 Count	30 Count	21 Count
1770064865	508 Count	30 Count	21 Count
1770062938	506 Count	23 Count	21 Count
1770061012	504 Count	23 Count	21 Count
1770059085	502 Count	23 Count	21 Count
1770057158	500 Count	23 Count	21 Count
1770055231	498 Count	23 Count	21 Count
1770053305	496 Count	23 Count	21 Count
1770051378	494 Count	23 Count	21 Count
1770049451	492 Count	23 Count	21 Count
1770049045	491 Count	23 Count	21 Count
1770047118	489 Count	23 Count	21 Count
1770045192	487 Count	23 Count	21 Count
1770043265	485 Count	23 Count	21 Count
1770041338	483 Count	23 Count	21 Count
1770039412	481 Count	23 Count	21 Count
1770037485	479 Count	23 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)