K0FTT Automobiles

My position About ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1768146601	425 Count	916 Count
1768145997	424 Count	915 Count
1768145394	423 Count	915 Count
1768144790	422 Count	913 Count
1768144186	421 Count	910 Count
1768143583	420 Count	908 Count
1768142980	419 Count	906 Count
1768142376	418 Count	904 Count
1768141772	417 Count	902 Count
1768141169	416 Count	901 Count
1768140566	415 Count	899 Count
1768139962	414 Count	898 Count
1768139359	413 Count	896 Count
1768138756	412 Count	892 Count
1768138152	411 Count	889 Count
1768137548	410 Count	886 Count
1768136945	409 Count	883 Count
1768136342	408 Count	881 Count
1768135738	407 Count	880 Count
1768135134	406 Count	879 Count
1768134529	405 Count	878 Count
1768133926	404 Count	875 Count
1768133323	403 Count	872 Count
1768132719	402 Count	870 Count
1768132116	401 Count	867 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)