K0FTT Automobiles

My position About ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768191632	122 Count	390 Count	110 Count
1768189829	107 Count	343 Count	96 Count
1768188060	87 Count	302 Count	81 Count
1768186257	73 Count	260 Count	68 Count
1768184454	58 Count	209 Count	54 Count
1768182651	45 Count	161 Count	42 Count
1768180848	33 Count	119 Count	31 Count
1768179045	22 Count	80 Count	21 Count
1768177242	9 Count	37 Count	9 Count
1768175439	325 Count	1017 Count	293 Count
1768173636	315 Count	972 Count	284 Count
1768171833	304 Count	931 Count	274 Count
1768170029	294 Count	897 Count	265 Count
1768168227	283 Count	860 Count	255 Count
1768166457	269 Count	831 Count	246 Count
1768164654	258 Count	791 Count	236 Count
1768162851	248 Count	761 Count	227 Count
1768161048	237 Count	724 Count	217 Count
1768159245	227 Count	688 Count	208 Count
1768157442	215 Count	645 Count	197 Count
1768155639	200 Count	605 Count	183 Count
1768153836	187 Count	562 Count	171 Count
1768152033	176 Count	523 Count	161 Count
1768150230	165 Count	480 Count	151 Count
1768148427	152 Count	436 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)