K0FTT Automobiles

My position About ☰

reset

SP5RT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5RT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1764270567	286 Count	858 Count	280 Count
1764266966	266 Count	771 Count	261 Count
1764263365	231 Count	658 Count	227 Count
1764259765	169 Count	464 Count	166 Count
1764256167	147 Count	378 Count	145 Count
1764252566	58 Count	243 Count	57 Count
1764248965	22 Count	96 Count	22 Count
1764245365	311 Count	1050 Count	289 Count
1764241764	270 Count	897 Count	249 Count
1764238163	245 Count	816 Count	225 Count
1764234566	226 Count	748 Count	207 Count
1764230966	205 Count	655 Count	187 Count
1764227365	136 Count	487 Count	133 Count
1764223764	83 Count	339 Count	81 Count
1764220164	43 Count	194 Count	42 Count
1764216563	20 Count	81 Count	20 Count
1764212966	372 Count	1054 Count	361 Count
1764209365	351 Count	971 Count	341 Count
1764205764	330 Count	889 Count	321 Count
1764202164	309 Count	807 Count	301 Count
1764198563	289 Count	731 Count	282 Count
1764194962	267 Count	644 Count	261 Count
1764191368	249 Count	570 Count	244 Count
1764187767	230 Count	493 Count	226 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)