K0FTT Automobiles

My position About ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765981957	71 Count	186 Count	70 Count
1765980156	23 Count	85 Count	23 Count
1765978355	359 Count	1006 Count	347 Count
1765976555	332 Count	931 Count	321 Count
1765974754	292 Count	841 Count	282 Count
1765972953	253 Count	758 Count	244 Count
1765971152	227 Count	682 Count	219 Count
1765969352	204 Count	613 Count	197 Count
1765967551	163 Count	518 Count	157 Count
1765965750	141 Count	450 Count	136 Count
1765963950	104 Count	366 Count	100 Count
1765962157	84 Count	292 Count	81 Count
1765960356	67 Count	214 Count	65 Count
1765958555	49 Count	147 Count	48 Count
1765956755	26 Count	81 Count	26 Count
1765954954	305 Count	1019 Count	292 Count
1765953153	282 Count	950 Count	270 Count
1765951352	250 Count	859 Count	239 Count
1765949552	236 Count	793 Count	226 Count
1765947751	219 Count	729 Count	210 Count
1765945950	202 Count	661 Count	194 Count
1765944150	181 Count	586 Count	174 Count
1765942349	157 Count	502 Count	151 Count
1765940556	131 Count	426 Count	126 Count
1765938755	108 Count	353 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)