K0FTT Automobiles

My position About ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761874396	187 Count	567 Count	76 Count
1761873496	185 Count	562 Count	75 Count
1761872595	183 Count	558 Count	74 Count
1761871694	181 Count	553 Count	73 Count
1761870793	179 Count	548 Count	72 Count
1761869893	177 Count	543 Count	71 Count
1761868992	175 Count	538 Count	70 Count
1761868091	173 Count	533 Count	69 Count
1761867190	171 Count	528 Count	68 Count
1761866290	169 Count	523 Count	67 Count
1761865389	167 Count	518 Count	66 Count
1761864488	165 Count	513 Count	65 Count
1761863587	163 Count	509 Count	64 Count
1761862707	161 Count	504 Count	63 Count
1761861806	159 Count	499 Count	62 Count
1761860905	157 Count	494 Count	61 Count
1761860005	156 Count	490 Count	61 Count
1761859104	154 Count	485 Count	60 Count
1761857302	150 Count	475 Count	58 Count
1761856401	148 Count	470 Count	57 Count
1761855501	146 Count	465 Count	56 Count
1761854600	144 Count	460 Count	55 Count
1761853699	142 Count	455 Count	54 Count
1761852798	140 Count	450 Count	53 Count
1761851898	138 Count	445 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)