K0FTT Automobiles

My position About ☰

reset

SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762082703	454 Count	900 Count
1762080902	453 Count	898 Count
1762079101	452 Count	895 Count
1762077301	451 Count	893 Count
1762075500	450 Count	890 Count
1762073700	449 Count	888 Count
1762071899	448 Count	885 Count
1762070099	447 Count	883 Count
1762068298	446 Count	880 Count
1762066498	445 Count	878 Count
1762064695	444 Count	875 Count
1762062902	439 Count	871 Count
1762061102	438 Count	868 Count
1762059301	437 Count	866 Count
1762057500	436 Count	863 Count
1762055700	435 Count	861 Count
1762053900	434 Count	858 Count
1762052098	433 Count	856 Count
1762050296	432 Count	853 Count
1762048496	431 Count	851 Count
1762046695	430 Count	848 Count
1762044896	429 Count	846 Count
1762043094	428 Count	843 Count
1762041301	423 Count	839 Count
1762039500	422 Count	836 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)