K0FTT Automobiles

My position About ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765988181	42 Count	124 Count	18 Count
1765986380	41 Count	122 Count	18 Count
1765984579	40 Count	115 Count	18 Count
1765982779	39 Count	114 Count	18 Count
1765980978	38 Count	112 Count	18 Count
1765979177	37 Count	110 Count	18 Count
1765977377	36 Count	108 Count	18 Count
1765975576	35 Count	106 Count	18 Count
1765973784	34 Count	104 Count	18 Count
1765971984	33 Count	102 Count	18 Count
1765970183	32 Count	100 Count	18 Count
1765968382	31 Count	98 Count	18 Count
1765966582	30 Count	95 Count	18 Count
1765964781	29 Count	92 Count	18 Count
1765962980	28 Count	85 Count	18 Count
1765961180	27 Count	83 Count	18 Count
1765959379	26 Count	81 Count	18 Count
1765957578	25 Count	79 Count	18 Count
1765955777	24 Count	77 Count	18 Count
1765953976	23 Count	75 Count	18 Count
1765952184	22 Count	73 Count	18 Count
1765950383	21 Count	71 Count	18 Count
1765948582	20 Count	70 Count	18 Count
1765946781	17 Count	38 Count	16 Count
1765944980	0 Count	2 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)