K0FTT Automobiles

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1748017970	4 Count	379 Count
1748017369	3 Count	332 Count
1748016767	2 Count	251 Count
1748016166	1 Count	176 Count
1748015610	0 Count	100 Count
1748015009	12 Count	1074 Count
1748014408	11 Count	971 Count
1748013806	10 Count	888 Count
1748013205	9 Count	792 Count
1748012604	8 Count	709 Count
1748012003	7 Count	621 Count
1748011401	6 Count	543 Count
1748010800	5 Count	456 Count
1748010199	4 Count	372 Count
1748009598	3 Count	307 Count
1748008996	1 Count	232 Count
1748008394	0 Count	127 Count
1748007793	12 Count	1012 Count
1748007192	11 Count	909 Count
1748006591	10 Count	784 Count
1748005989	9 Count	709 Count
1748005388	8 Count	634 Count
1748004787	7 Count	549 Count
1748004186	6 Count	457 Count
1748003584	5 Count	386 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)