K0FTT Automobiles

My position About ☰

reset

SP8C-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770119139	106 Count	106 Count	106 Count
1770117339	106 Count	106 Count	106 Count
1770115539	106 Count	106 Count	106 Count
1770113739	106 Count	106 Count	106 Count
1770111938	106 Count	106 Count	106 Count
1770110138	106 Count	106 Count	106 Count
1770108338	106 Count	106 Count	106 Count
1770106538	106 Count	106 Count	106 Count
1770104738	106 Count	106 Count	106 Count
1770102938	106 Count	106 Count	106 Count
1770101138	106 Count	106 Count	106 Count
1770099338	94 Count	94 Count	94 Count
1770097537	94 Count	94 Count	94 Count
1770095737	80 Count	80 Count	80 Count
1770093937	80 Count	80 Count	80 Count
1770092137	80 Count	80 Count	80 Count
1770090337	80 Count	80 Count	80 Count
1770088537	80 Count	80 Count	80 Count
1770086737	80 Count	80 Count	80 Count
1770084937	80 Count	80 Count	80 Count
1770081340	80 Count	80 Count	80 Count
1770079540	80 Count	80 Count	80 Count
1770077740	80 Count	80 Count	80 Count
1770075940	80 Count	80 Count	80 Count
1770074140	80 Count	80 Count	80 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)