K0FTT Automobiles

My position About ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765992145	143 Count	644 Count	100 Count
1765989746	139 Count	613 Count	98 Count
1765982551	108 Count	484 Count	77 Count
1765978949	102 Count	464 Count	74 Count
1765974146	92 Count	416 Count	68 Count
1765970546	85 Count	384 Count	64 Count
1765964554	47 Count	261 Count	35 Count
1765959749	33 Count	197 Count	25 Count
1765956147	22 Count	130 Count	17 Count
1765952545	6 Count	61 Count	4 Count
1765948943	116 Count	1002 Count	62 Count
1765946544	110 Count	963 Count	58 Count
1765944154	102 Count	921 Count	56 Count
1765942951	99 Count	903 Count	54 Count
1765941753	97 Count	886 Count	53 Count
1765939349	91 Count	842 Count	49 Count
1765935747	84 Count	766 Count	45 Count
1765934548	82 Count	748 Count	44 Count
1765933347	79 Count	724 Count	42 Count
1765930944	75 Count	683 Count	40 Count
1765929745	72 Count	663 Count	38 Count
1765928545	69 Count	641 Count	36 Count
1765927342	67 Count	622 Count	35 Count
1765926143	65 Count	603 Count	34 Count
1765924943	62 Count	584 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)