K0FTT Automobiles

My position About ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1770036745	960 Count	637 Count	422 Count
1770033144	957 Count	634 Count	420 Count
1770029543	954 Count	631 Count	418 Count
1770025942	951 Count	628 Count	416 Count
1770022341	948 Count	625 Count	414 Count
1770018740	945 Count	622 Count	412 Count
1770015139	942 Count	619 Count	410 Count
1770011538	939 Count	616 Count	408 Count
1770007937	936 Count	613 Count	406 Count
1770004336	933 Count	610 Count	404 Count
1770000735	930 Count	607 Count	402 Count
1769997135	927 Count	604 Count	400 Count
1769993534	924 Count	601 Count	398 Count
1769989933	921 Count	598 Count	396 Count
1769986332	918 Count	595 Count	394 Count
1769982731	915 Count	592 Count	392 Count
1769979130	912 Count	589 Count	390 Count
1769975529	910 Count	587 Count	389 Count
1769971928	907 Count	585 Count	387 Count
1769968328	904 Count	582 Count	385 Count
1769964727	901 Count	579 Count	383 Count
1769961126	898 Count	576 Count	381 Count
1769957525	895 Count	573 Count	379 Count
1769953924	892 Count	570 Count	377 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)