K0FTT Automobiles

My position About ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769686068	63 Count	484 Count	61 Count
1769684268	43 Count	322 Count	42 Count
1769682467	24 Count	173 Count	24 Count
1769680666	133 Count	1090 Count	123 Count
1769678865	112 Count	919 Count	103 Count
1769677065	92 Count	743 Count	84 Count
1769675264	72 Count	563 Count	65 Count
1769673463	50 Count	400 Count	44 Count
1769671662	28 Count	196 Count	23 Count
1769669862	4 Count	2 Count	0 Count
1769668069	306 Count	990 Count	288 Count
1769666268	273 Count	798 Count	256 Count
1769664467	247 Count	693 Count	231 Count
1769662667	225 Count	632 Count	210 Count
1769660866	207 Count	584 Count	193 Count
1769659065	190 Count	534 Count	177 Count
1769657265	172 Count	483 Count	160 Count
1769655464	152 Count	431 Count	141 Count
1769653663	132 Count	374 Count	122 Count
1769651862	114 Count	327 Count	105 Count
1769650061	96 Count	281 Count	88 Count
1769648261	78 Count	227 Count	71 Count
1769646468	55 Count	179 Count	53 Count
1769644667	39 Count	133 Count	38 Count
1769642867	19 Count	69 Count	19 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)