K0FTT Automobiles

My position About ☰

reset

EA5URV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5URV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1770004101	10 Count	970 Count
1770000798	9 Count	910 Count
1769997494	8 Count	851 Count
1769994191	7 Count	797 Count
1769990888	6 Count	734 Count
1769987584	5 Count	673 Count
1769985803	4 Count	621 Count
1769982500	3 Count	534 Count
1769979196	2 Count	419 Count
1769975893	1 Count	271 Count
1769972589	0 Count	138 Count
1769969286	9 Count	1087 Count
1769965983	8 Count	942 Count
1769964328	7 Count	942 Count
1769961025	6 Count	800 Count
1769957721	5 Count	633 Count
1769954418	4 Count	483 Count
1769951115	3 Count	338 Count
1769949334	2 Count	281 Count
1769946031	1 Count	187 Count
1769942727	0 Count	87 Count
1769939422	11 Count	1101 Count
1769936119	10 Count	939 Count
1769932816	9 Count	782 Count
1769929513	8 Count	708 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)