K0FTT Automobiles

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1766085973	51 Count	608 Count
1766084173	50 Count	595 Count
1766082372	49 Count	585 Count
1766080572	48 Count	573 Count
1766078771	47 Count	564 Count
1766076970	46 Count	552 Count
1766075178	45 Count	539 Count
1766069776	42 Count	503 Count
1766067975	41 Count	491 Count
1766066175	40 Count	478 Count
1766064375	39 Count	466 Count
1766062571	38 Count	453 Count
1766060770	37 Count	441 Count
1766058969	36 Count	430 Count
1766057169	35 Count	418 Count
1766055368	34 Count	404 Count
1766054878	33 Count	399 Count
1766054685	32 Count	398 Count
1766054343	31 Count	394 Count
1766054310	30 Count	394 Count
1766054051	29 Count	392 Count
1766053987	28 Count	392 Count
1766053550	27 Count	387 Count
1766051749	26 Count	371 Count
1766049948	25 Count	343 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)