K0FTT Automobiles

My position About ☰

reset

WB6ETY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1769990070	1372	708	343	702	33
1769989389	1372	707	349	698	35
1769989350	1372	707	343	702	35
1769988631	1372	706	343	698	34
1769987911	1372	705	349	698	37
1769987589	1372	705	343	698	33
1769987190	1377	705	343	698	35
1769986470	1374	704	343	698	37
1769985789	1372	701	343	694	34
1769985750	1372	701	349	694	34
1769985031	1374	700	343	694	33
1769984310	1372	699	349	694	34
1769983989	1372	698	343	689	33
1769983590	1372	698	343	689	33
1769982870	1372	697	343	689	33
1769982189	1374	697	343	689	34
1769982150	1377	697	343	689	33
1769981431	1372	696	343	689	33
1769980710	1372	695	343	689	33
1769980389	1372	694	343	689	36
1769979990	1372	694	343	684	33
1769979270	1372	692	343	684	33
1769978589	1372	691	338	684	34
1769978550	1372	690	338	684	33
1769977830	1374	689	343	680	33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)