K0FTT Automobiles

My position About ☰

reset

SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770102336	129 Count	283 Count	123 Count
1770100541	106 Count	250 Count	105 Count
1770098741	82 Count	211 Count	82 Count
1770096940	583 Count	1042 Count	554 Count
1770095139	541 Count	948 Count	513 Count
1770093339	518 Count	914 Count	491 Count
1770091538	494 Count	877 Count	468 Count
1770089738	461 Count	831 Count	436 Count
1770087937	438 Count	794 Count	414 Count
1770086136	415 Count	749 Count	392 Count
1770082535	361 Count	666 Count	340 Count
1770080735	336 Count	622 Count	316 Count
1770078940	303 Count	576 Count	288 Count
1770077139	277 Count	528 Count	263 Count
1770075339	249 Count	481 Count	236 Count
1770073538	217 Count	405 Count	205 Count
1770071737	182 Count	325 Count	171 Count
1770069937	157 Count	279 Count	147 Count
1770068136	126 Count	230 Count	117 Count
1770066336	96 Count	163 Count	88 Count
1770064535	69 Count	119 Count	62 Count
1770062734	50 Count	81 Count	44 Count
1770060934	23 Count	34 Count	18 Count
1770059133	4 Count	0 Count	0 Count
1770057339	553 Count	982 Count	522 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)